- Concentrated formula based on natural rubber. Allows to mould both simple and complicated shapes in small or large sizes. Can also be used to make rubber masks.
- Apply the latex with a brush on the object to be moulded. Take care to protect your brushes by coating them with dishwashing liquid.
- Allow the first layer to dry 10 minutes.
- Apply a second coat. While still wet place gauze to strengthen the mould and immediately apply a third layer on top.
- Allow to dry 10 minutes and apply a fourth layer.
- Allow to dry 6 hours. To prevent the latex from sticking to itself sprinkle the outside of mould with Demoulding Talc and unmould.
- Pour the reproductive material: plaster crystal resin ….. Unmould. Let dry and decorate.
- The maximum temperature that a latex mould can withstand is 50C.
- To thin the latex you can add up to 5% of water stirring slowly.
all categories